AVATTO S06 IR gateway compatible with OpenMQTTGateway

For this new post we will make it compatible with OpenMQTTGateway; the BAKEEY IR remote on banggood or AVATTO S06 on Aliexpress (the links are affiliated).

Note that this article apply only to the non tuya compatible S06 models. The newest models, marked as tuya compatible are not based on ESP so not compatible with OMG.

From this discussion on Home Assistant forum, I have deducted that the AVATTO gateways may be uploaded with new firmware, so I bought 2 of them. Thanks to their pinout information I was able to quickly get this device up and running with OMG.

Overview

The S06 is a compact IR bridge with FCC, CE, and RoHS marks,you can find it for less than 15$. Here are some photos:

Image may be NSFW.
Clik here to view.

Image may be NSFW.
Clik here to view.

Disassembly

It is not so easy to open, you will need a thin plate, insert it on the junction between the two box parts and do a lever effect at several locations.

Image may be NSFW.
Clik here to view.

• ESP8266

• 1mb flash

• 50K RAM

So we may be able to flash it with an FTDI and upload OMG.

Here is the LED setup:

Image may be NSFW.
Clik here to view.

It has 7 IR emitters LED, one receiver, and one blue LED.

the IR LED is bigger compared to my other AVATTO round gateway.

Upload OpenMQTTGateway.

Set your FTDI to 3.3V

Connect an FTDI following this wiring to the board:

• BOARD GND - FTDI GND

• BOARD RX - FTDI TX

• BOARD TX - FTDI RX

• BOARD 3.3V- FTDI VCC

• BOARD IO0 - BOARD GND

1. Connect the FTDI to your computer

2. Open your Arduino IDE or platformio

3. With platformio  type the following command:  platformio run --target erase

4. With the arduino IDE :Erase flash "All flash content"  & DOUT mode

5. And now you can flash it with OpenMQTTGateway, with platformio, type the following command: platformio run --target upload

The board is an ESP8266 1MB, here is the configuration used with PIO in the platformio.ini file:

[env:avatto-ir]

platform = ${com.esp8266_platform}

board = esp01_1m

lib_deps =

  ${com-esp.lib_deps}

  ${libraries.irremoteesp}

  ${libraries.esp8266_mdns}

build_flags = 

  ${com-esp.build_flags}

  '-DZgatewayIR="IR"'

  '-DTRIGGER_GPIO=13'

  '-DLED_SEND=4'

  '-DIR_EMITTER_GPIO=14'

  '-DIR_RECEIVER_GPIO=5'

  '-DGateway_Name="OpenMQTTGateway_AVATTO_IR"'

The IR receiver use the GPIO5,

the IR emitters is on GPIO14, 

the blue LED on GPIO4

the reset button on GPIO13.

Once flashed you can set up your credentials with your smartphone, click one save and you should see the gateway coming on your broker.

You can now send and receive IR signals and integrate the board with your favorite automation controller!

Image may be NSFW.
Clik here to view.

And now you should be able to control your IR devices with a powerful board.